Vermont Castings NV580 Instructions d'exploitation télécharger pdf (Page 10)

Vermont Castings Majestic Products NV360/580 Series

20003565

Log Installation

1 . Remove window frame assembly. (Refer to page 10)

2. Remove logs from packaging.

As with all plastics — these are not toys

and should be kept away from children

and infants.

3. Place rear log on rear bracket (ensure log is seated

properly, leveled and centered to the unit), so it will

not move from side to side and is firmly positioned

on the bracket. Be sure log is as far back as possible

on bracket.

Only glass approved for use in Majestic

Fireplaces products may be used for

replacement.

• The use of any non-approved replacement glass will

void all product warranties.

• Care must be taken to avoid breakage of the glass.

• Under no circumstances should this appliance be

operated without the front glass or with broken

glass. Replacement of the glass (with gasket) as

supplied by the manufacturer should be completed

by a licensed qualified service person.

• Replacement glass (complete with gasket) is

available through your Majestic Fireplaces dealer

and should only be installed by a licensed qualified

service person.

Louvre Removal

To remove louvre

assembly top, pull

louvre up, then lift out.

(Fig. 9) The bottom

louvre assembly is

hinged at the bottom

edge and swings

down.

Operating Instructions

Glass Information

Clamps

Glass Frame

Fireplace

Front

Glass

Panel

Glass

Panel

Pull

Clamp Hook

G584-501

Push

Clamp Handle

Fig. 10 Glass panel removal.

Fig. 9 Remove louvre assembly

top.

Louvre

Assembly

Top

Glass Panel

FP444

Window Frame Assembly Removal

1. Shut off gas.

2. Let the fireplace cool if it has been operating.

3. Remove louvre assembly top. (Refer to Louvre

Removal, Fig. 9)

4. Open the bottom louvre assembly.

5. Release the two (2) clamps at the bottom of the

window frame by pulling down on the clamp handles.

6. Lift off the window frame assembly as shown. (Fig.

10)

7. To reinstall window frame assembly follow the above

procedure in reverse.

Glass Cleaning

It is necessary to clean the glass periodically. During

start-up, condensation, which is normal, forms on the

inside of the glass and causes lint, dust and other

airborne particles to cling to the glass surface. Also

initial paint curing may deposit a slight film on the glass.

After the first two weeks of operation, it is

recommended the glass be cleaned two or three times

with a non-ammonia household cleaner and warm

water (gas fireplace glass cleaner is recommended).

After initial use glass should be cleaned two or three

times during heating season.

Clean glass after first two weeks of

operation.

Do not clean glass when hot.

Do not use abrasive cleaners.

Do not strike or slam the glass.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Vermont Castings NV580 Instructions d'exploitation Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Vermont Castings NV580