Vermont Castings UVL30RP Instructions d'exploitation télécharger pdf (Page 4)

UVL Series

Planning

Planning the installation is an important first step. It will

save time and money later in the actual installation. In

planning the installation, consider:

• Where the heater will be located.

• All components needed to complete the installation.

• DO NOT use this heater in sleeping quarters, mobile

homes, or in recreational vehicles.

• Installation and repair should be done by a qualified

service person.

• DO NOT use this heater if any part has been under

water. Immediately call a qualified technician to inspect

the appliance and replace any part of the control system

and any gas control which has been under water.

• When used as an unvented heater, always ensure there

is adequate ventilation from the room where the appliance

is operating. This appliance is equipped with an ODS

(oxygen depletion sensor) pilot light safety system

designed to shut off the appliance if enough fresh air is

not available.

THIS APPLIANCE MUST NOT BE USED WITH GLASS

DOORS IN A CLOSED POSITION .

Keep the burner and control compartment clean. See

installation and operating instructions supplied with the

heater.

WARNING: During manufacturing, fabricating and

shipping, various components of this appliance are

treated with certain oils, films or bonding agents.

These chemicals are not harmful, but may produce

annoying smoke and smells as they are burned off

during the initial operation of the appliance, possibly

causing headaches or eye or lung irritation. This is a

normal and temporary occurrence. The initial break-in

operation should last 2-3 hours with the burner at its

highest setting. Provide maximum ventilation by

opening windows, doors and the chimney flue to

allow odors to dissipate. Any odors remaining after

this initial break-in will be slight and will disappear

with continued use.

This appliance operates as an unvented domestic room

heater when fitted to a masonry or factory-built wood-

burning fireplace with the flue damper closed, or as a

decorative appliance when the flue damper is fully open. It

must not be used for any other purpose and must be fitted

in a masonry or factory-built fireplace or ventless firebox

enclosure.

State, provincial or local codes may only allow operation

of this appliance in a vented configuration. Check your

state or local codes. If unvented room heaters are not

permitted, the fireplace vent damper must be locked at the

minimum vent area required by local codes or by the

National Fuel Gas Code (ANSI Z223.1/NFPA 54, latest

edition).

When installed as a Decorative Gas Appliance for

installation in a solid-fuel burning fireplace, a mini-

mum permanent free opening of 29 square inches

must be maintained with a fixed damper stop provided

with the appliance. Minimum flue size for this appli-

ance is 29 square inches.

Installation Precautions

1. This vent-free gas appliance and its components

have been tested and will operate safely when

installed in accordance with this Installation Manual.

Read all instructions before starting the installation,

and follow these instructions carefully during

installation to maximize the appliance's benefit and

safety. Failure to follow them will void your warranty

and may present a fire hazard.

2. After opening the carton, refer to

Replacement

Parts

on Page 17 and 18, and remove the various

parts.

Report to your dealer if any parts were damaged in

shipment.

• CFM Specialty Home Products warranty

will be voided by, and CFM Specialty Home

Products disclaims any responsibility for,

the following actions:

• Installation of any damaged appliance.

• Modification of the appliance.

• Installation other than as instructed by

CFM Specialty Home Products.

• Improper positioning of the gas logs.

• Installation and/or use of any component

part or accessory not manufactured or

approved by CFM Specialty Home Prod-

ucts, not withstanding any independent

testing laboratory or other third-party

approval of such component part or acces-

sory.

Any such action may create a possible fire

hazard.

Consult your local building codes.

This heater shall not be installed in a confined

space unless provisions are made for adequate

combustion and ventilation air.

Improper installation, adjustment, alteration,

service or maintenance can cause injury or

property damage. Refe to this manual for

assistance or additional information, consult a

qualified installer, service agency or the gas

supplier.

WARNING!

Proposition 65 Warning: Fuels used in gas,

woodburning or oil fired appliances, and the

products of combustion of such fuels, contain

chemicals known to the State of California to

cause cancer, birth defects and other reproductive

harm.

California Health & Safety Code Sec. 25249.6

1 2 3 4 5 6 7 8 9 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

Vermont Castings UVL30RP Instructions d'exploitation Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Vermont Castings UVL30RP