Vermont-castings FK28/2960 Manuel d'utilisateur télécharger pdf (Page 3)

30000275

Jefferson Installation Procedure

1. Attach the snapstat assembly to the snapstat bracket

with two sheet metal screws. (Fig. 8) Remove the

1/4-20 x 3/8” hex head bolt installed in the hole in the

right rear ledge of the ﬁrebox. Use that bolt to secure

the snapstat bracket to the ﬁrebox. The mounting

hole is slotted to allow you to adjust the bracket so

that the snapstat bracket head makes contact with

the ﬁrebox. (Fig. 9)

2. Attach the fan to the rear shroud by engaging the

upper ﬂange of the fan skirt under the lower edge of

the shroud and se cure the skirt with the four screws

and one star washer provided. (Fig. 9,10)

3. The rheostat control switch attaches to the left side

of the valve bracket at the front of the stove. (Fig. 11)

• Remove the plug from the rheostat bracket.

• Insert the switch box shaft through the hole in

the back of the right side of the valve bracket,

aligning the locator pin with the smaller hole in

that bracket.

• Attach the retaining nut to the switch control shaft

to secure it to the plate.

• Attach the control knob to the rheostat shaft.

• Use the wire tie to secure the fan and rheostat

wire harnesses together.

ST239

FDV attach snapstat

12/13/99 djt

1/4-20 x 3/8”

Phillips Screw

1/2”

Sheet

Metal

Screw

Snapstat

Snapstat Bracket

ST239

Fig. 8 Snapstat assembly and installation.

ST240

FDV attach fan

12/13/99 djt

Upper

Flange

Control

Valve

ST240

Fig. 9 The upper ﬂange of the fan skirt should be located

behind the lower edge of the shroud.

ST240

FDV attach fan

12/13/99 djt

ST241

Fig. 10 Correct position of fan skirt installation.

ST347a

JUV

FK28

rheostat install

9/21/00

Retaining Nut

Control Knob

ST347a

Fig. 11 Attach rheostat.

Rheostat

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Vermont-castings FK28/2960 Manuel d'utilisateur Page 3

Commentaires sur ces manuels