Vermont-castings LHE30CSLB Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
Attaching the Surround
1. For ʻCʼ series units, attach the switch wires to
the valve. The wires attach to the ʻTH/TPʼ and the
ʻTHʼ terminals (the top and bottom terminals) on
the valve. Bring the wires to the side of the firebox.
If the switch housing is on the left side of the sur-
round, bring the wires to the left side of the firebox.
Bring the wires up through the bottom of the switch
housing, and out through the side. (Fig. 4) Attach the
wires to the switch by pressing the wire connectors
onto the prongs of the switch. Press-fit the switch
into the housing. (Fig. 4)
2. Position surround in front of fireplace insert and,
with the help of an assistant, gently lift the surround
up and over the top flange and right and left side
flanges. Secure surround by applying downward
pressure until the lower brackets have engaged onto
the left and right side flanges. (Fig. 5)
3. This completes the assembly.
KT396
attach surround
5/19/03 djt
Top Flange
Left
Side
Flange
Right
Side
Flange
KT396
Fig. 5 Attach the cast surround to the fireplace insert.
Lift surround up and
over top flange. Apply
downward pressure.
4. Attach the two (2) lower brackets to the bottoms of
the columns with two (2) 3/8” phillips pan head bolts
each. (Fig. 2) NOTE: When positioning the right
column lower bracket, make sure one of the hooked
flanges is in the upper right hand corner and facing
towards you. The other hooked flange will be in the
opposite lower corner and facing away from you.
(Fig. 2)
The left column lower bracket is the opposite.
5. For ʻCʼ series units, choose which side of the sur-
round should have the ON/OFF switch, and attach
the switch housing to the back of that column with
one (1) 1/4-20 x 3/8” phillips pan head screw. (Fig. 4)
KT398
Upper bracket
side view
5/20/03 djt
Deeper Set
Back
LHER20
LHER30
LHEC20
LHEC30
KT398
Fig. 3 Determine which bracket is correct for the installation.
KT395
Attach
switch housing
5/19/03 djt
Upper Bracket
Switch
Housing
Switch
Connectors
Switch Wires
KT395
Fig. 4 (ʻCʼ Series units only) Attach the switch housing and
the switch. The housing can be attached to either column.
MHSC
149 Cleveland Drive • Paris, Kentucky 40361
www.mhsc.com
Vue de la page 1
1 2

Commentaires sur ces manuels

Pas de commentaire