Vermont Castings Vigilant II 2310 Instructions d'exploitation télécharger pdf (Page 9)

Vermont Castings Vigilant

2000898

VIGILANT

24" 

(610mm)

Max.

ST687

chimney connector

8/7/01 djt

Prefabricated

Chimney

Single-wall

Chimney Connector

Chimney

Connector

Heat Shield

Bottom

Heat

Shield

ST687

 Chimney connector heat shields may be used to re-

duce clearances when single-wall connectors are used.





When a rear heat shield is used on the stove and a

double wall chimney connector is used, the rear clear-

ance is 15¹⁄₂" (395 mm) and the chimney connector

clearance is 12" (300 mm).







Use of both stove and chimney connector heat shields,

on single-wall connectors, in top-exiting installations

reduces the required clearance. (Fig. 10)

13" (330mm)

18"

(460mm)

ST688

Vigilant

clearances

parallel,

rear heat shield,

chimney connector

heat shield

8/7/01 djt

ST688

 Minimum clearance, chimney connector heat shield,

rear heat shield.



A properly constructed wall shield may be used to

change an unprotected wall to a protected wall, allow-

ing the clearances given in the right half of the Clear-

ance Chart.

Wall shields should be

constructed of 24 gauge

or heavier sheetmetal,

1/2” noncombustible insu-

lation board, or common

brick laid on at (3¹⁄₂" side

down). Shields must be

spaced out from the com-

bustible wall or ceiling 1"

on noncombustible spac-

ers. The spacers should

not be directly behind the

stove or chimney connec-

tor.

Air must be able to ow

between the wall and the

shield. At least one-half

(50%) of the bottom 1"

of the shield should be

open and the shield must

stop 1" from the ceiling.

Protect the top opening

with metal screening to

prevent objects from fall-

ing behind the shield.

Rear wall shields must extend 18" above the top of the

stove or to within 1" of the ceiling, must be centered

behind the stove, and must be a minimum of 48" (1220

mm) wide by 48" high.

Side wall shields must be 48" (1220 mm) wide by 44"

high, and must extend 15" (380 mm) beyond the front

of the stove as measured from a point on the wall that

is on the same plane as the door glass.

ST248

wall shield construction

12/14/99 djt

Air Flow

Wall Shield

Noncom-

bustible

Spacer and

Fasteners

Drywall

Stud Wall Fram-

ing

Air Flow

ST248

 Wall shield con-

struction.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Vermont Castings Vigilant II 2310 Instructions d'exploitation Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Vermont Castings Vigilant II 2310